top of page

Holding Components

holding component

knife roll cutting module industrial knife roll holding compenents flex knife cutting flex cutting knife holder knife roll anvil roll knife roll flex knife industrial converting machine nonwoven converting replacement knives knife anvil roll

Even the best knives can not be used to their full potential in worn out clamps & holders. Every detail of Everwear components, from material selection to design features, will improve knife life and minimize costly machine stoppages. We can evaluate your current design, offer recommendations for improvement, and develop a maintenance plan to maximize your holding power. Component upgrades and maintenance are the perfect complement to you organization's continuous improvement plan.

Solutions for Better Cutting - Knife Holders

industrial knife holders flex cutting flex knife cutting knife roll anvil roll industrial cutting modules drop in cut stations

Relief

Torque

No relief Knife Holder

Problem

No relief can cause cutting problems when the knife does not seat properly.

Relief Knife Holder

Solution

Relief ensures a proper seat for a precision ground knife.

over torqued Knife Holder

Problem

An over torqued knife holder causes uneven cutting and more knife stress.

Proper torque Knife Holder

Solution

Proper torque is improtant for better cutting and longer knife life.

Corrosion

Finish

Rust and low grade material Knife Holder

Problem

Rust and low grade material create knife holding problems and uneven cutting.

Higher grade material Knife Holder

Solution

Higher grade materials reduce corrosion and increase holder and knife life. Surface coatings are available.

Poor finish Knife Holder

Problem

Poor finish allows knife to slip during cutting operation.

Ground finish Knife Holder

Solution

Ground finish prevents knife movement for full holding power.

Parallel

Debris

Parallel tolerance

Problem

Parallel tolerance is critical to ensure long term even cutting.

Parallel Knife Holder

Solution

Holder is parallel and machined to higher tolerances, compatable with Everwear knives.

Debris and improper cleaning

Problem

Debris and improper cleaning causes an uneven cut and often results in knife breakage.

Cleaning procedures

Solution

Establish standard cleaning procedures for better cutting. Contact Everwear for more cleaning and maintenance tips.

PRODUCTS

bottom of page